Configuring Bfd Bring Up Timeout - Cisco ASR 9000 Series Routing Configuration Manual

Configuring BFD over MPLS Traffic Engineering LSPs
Command or Action
Step 3
bfd fast-detect
Example:
RP/0/RSP0/CPU0:router(config-if)#bfd
fast-detect
Step 4 bfd minimum-intervalmilliseconds
Example:
RP/0/RSP0/CPU0:router(config-if)#bfd
minimum-interval 2000
Step 5 bfd multiplier number
Example:
RP/0/RSP0/CPU0:router(config-if)#bfd multiplier
5
Step 6 commit
What to Do Next
Configure BFD bring up timeout interval.
Once LSP is signaled and BFD session is created, TE allows given time for the BFD session to come up. If
BFD session fails to come up within timeout, the LSP is torn down. Hence it is required to configure BFD
bring up timeout

Configuring BFD Bring up Timeout

Perform these steps to configure BFD bring up timeout interval. The default bring up timeout interval is 60
seconds.
Before You Begin
BFD must be enabled under MPLS TE tunnel interface.
SUMMARY STEPS
1. configure
2. interface tunnel-te interface-number
3. bfd bringup-timeout seconds
4. commit
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
284
Purpose
Enables BFD fast detection.
Configures hello interval in milliseconds.
Hello interval range is 100 to 30000 milliseconds. Default
hello interval is 100 milliseconds
Configures BFD multiplier detection.
BFD multiplier range is 3 to 10. Default BFD multiplier
is 3.
Implementing BFD