Executing Tasks - Sartorius cubis MPS Quick Reference Manual

Device parameters
Configure data output
Please check the printout parameters of
this task:
Task a New a Print a Overview
Com A; Com B
Printout interface:
Protocol (Com A): Print
Stand. printout (Com A) Standard 1
GLP printing (Com A): Off
PRINT
Print event (Com A):
Back Wizard Done
Please select task:
Task
Climate control
Climate control
Weighing
Basic weighing
Weighing
Sort Edit
5.3.3.2 Configuring Printouts in the System Settings (Menu).
h
The settings can only be modified as long as no task has been activated (ready
to start) in the operating mode. Make sure that basic weighing is active in the
operating mode.
t
Toggle to the system settings menu.
Menu
t
Open the
Configure data output
If the submenu is not selectable, check the operating mode and select basic
weighing.
y
The setting menu will open. Several options are not modifiable because they are
preset by the interface configuration.
The initial default setting and several examples of settings are described in the
following.
Next
5.4

Executing Tasks

After all required settings have been configured, you can now start and execute
a task.
D
t
If you haven't already done so, go to Task Management.
y
The task selection is displayed.
t
Touch the task of your choice
or:
Start
t
If the desired task has already been selected, (dark background and arrow on left),
Start
touch .
Start
y The program switches to the operating mode and the selected task is activated.
t
Follow the instructions on the display.
In this Quick Reference Guide, we only describe the applications "Weighing" and
"Climate Control." Complete information on all applications can be found in the user
manual for the Cubis
following website: http://www.sartorius.com.
submenu.
®
MCM model. The user manual can be downloaded from the
®
Cubis MPS Quick Reference Guide
Task Management
41