Setting The Location And Fuel; Flue Gas - TESTO 320 Instruction Manual

6 Using the product
6.2.1.4.

Setting the location and fuel

Before carrying out measurements, the location and fuel must be
correctly selected, see Folders / Locations, page 29 und see Fuels,
page 41.
6.2.2.

Flue gas

Call up function:
1. [
2. Select the fuel → [OK].
Carrying out the measurement:
1. Start measurement:
- The measured values are displayed.
2. End measurement:
Options
> [Options]
> [Options]
is deleted.
> [Options]
> [Options]
displayed as a flue gas matrix, see below.
> [Options]
measured values per display page.
> [Options]
> [Options]
during a measurement): the measured value display menu is
opened.
44
→
] Measurement options
[
If a separate measurement of CO undiluted has not yet
been carried out, this value is calculated using the
measured values of the flue gas probe and is updated
continuously.
If CO undiluted and/or a draught measurement has already
been carried out separately, the value obtained is applied.
[
→ Clipboard: data is saved to the clipboard.
→
Delete
→ Save: the measured values are saved in a record.
→
Fluegas
→
Number of
→ Recalibrate: the gas sensors are set to zero.
→
Measurement
→
[OK]
].
].
clipboard: any data saved to the clipboard
matrix: the measured values are
lines: change the number of
view: (This function is not available
→ → [OK].
Flue Gas