8 Tips and assistance
8.3.
Updating the instrument software
Under www.testo.com/download-center you can download the
current instrument software (Firmware) for testo 320 (registration
required).
> Unplug the mains unit and switch off the testo 320.
1. Hold down [▲].
2. Plug in the mains unit, continue holding down [▲].
-
The display shows
3. Release [▲].
4. Insert the connecting cable (0449 0047) into the USB-port on
the instrument, then connect it to the PC.
-
Your PC recognises the testo 320 as a removable medium.
5. Copy the new file (ap320rel.bin) to the detected removable
medium.
-
On the display the status bar progresses from left to right. This
process may take a few minutes.
6. Disconnect the connecting cable from the testo 320.
-
Once the instrument software (firmware) has been updated, the
system will automatically reboot and is ready for use.
70
Firmware update
along the bottom edge.