Switching Modes - YASKAWA CIMR-F7A Instruction Manual

Switching Modes

The mode selection display will appear when the MENU Key is pressed from a monitor or setting display.
Press the MENU Key from the mode selection display to switch between the modes.
Press the DATA/ENTER Key from the mode selection key to monitor data and from a monitor display to
access the setting display.
IMPORTANT
-6
3
MENU
Drive Mode
DATA
ENTER
ESC
DRIVE QUICK ADV VERIFYA.TUNE
Quick
MENU
DATA
Programming Mode
ENTER
ESC
DRIVE QUICK ADV VERIFYA.TUNE
Advanced
MENU
DATA
Programming Mode
ENTER
ESC
DRIVE QUICK ADV VERIFYA.TUNE
MENU
Verify Mode DATA
ENTER
ESC
DRIVE QUICK ADV VERIFYA.TUNE
Autotuning
MENU
DATA
Mode
ENTER
ESC
DRIVE QUICK ADV VERIFYA.TUNE
Mode Selection Displays
Lit Flashing
Fig 3.3 Mode Transitions
When running the Inverter after using Digital Operator, press the MENU Key to enter the drive mode (DRIVE
indicator will flash) and then press the DATA/ENTER Key from the drive mode display to bring up the monitor
display (DRIVE indicator will light). Run Commands can't be received from any other display. (Monitor display
in the drive mode will appear when the power is turned ON.)
Power ON
(Operation possible)
DRIVE QUICK ADV VERIFYA.TUNE
DATA
ENTER
ESC
DRIVE QUICK ADV VERIFYA.TUNE
DATA
ENTER
ESC
DRIVE QUICK ADV VERIFYA.TUNE
When returning from a setting
display, the rightmost digit
of the monitor display will
flash.
DRIVE QUICK ADV VERIFYA.TUNE
If a user constant is changed
the number will be dislayed. DATA
ENTER
ESC
DRIVE QUICK ADV VERIFYA.TUNE
Monitor Displays
Not lit
DATA
ENTER
DRIVE QUICK ADV VERIFYA.TUNE
DATA
ENTER
DRIVE QUICK ADV VERIFYA.TUNE
DATA
ENTER
DRIVE QUICK ADV VERIFYA.TUNE
Setting Displays