YASKAWA CIMR-F7A Instruction Manual page 472

No.
o2-04 kVA selection
Frequency reference setting
o2-05
method selection
Operation selection when digital
o2-06
operator is disconnected
o2-07 Cumulative operation time setting
Cumulative operation time selec-
o2-08
tion
o2-09
For factory adjustment
*19
o2-10 Fan operation time setting
Fault trace/fault history clear func-
o2-12
tion
Output power monitor clear selec-
o2-14
tion
o3-01 Copy function selection
o3-02 Read permitted selection
* 1. Not initialized. (Japanese standard specifications: A1-01 = 1, A1-02 = 2)
* 2. The factory setting will change when the control method is changed. The V/f control factory settings are given.
* 3. The factory setting is 1.0 when using flux vector control.
* 4. The factory setting is 2.00 s when Inverter capacity is 55 kW min.
The factory setting will change if the control method is changed. The open-loop vector factory setting is given.
* 5. By setting E2-11 (Motor rated output) the appropriate value will be set.
* 6. The factory setting depends on the Inverter capacity. The values for a 200 V Class Inverter for 0.4 kW are given.
* 7. The factory setting will change when the control method is changed. The flux vector control factory settings are given.
* 8. Only 1 (VT) can be set for 200 V Class 110 kW as well as 400 V Class 220 kW and 300 kW Inverters.
* 9. Setting for 200 V Class Inverters. For 400 V Class Inverters, double the value.
* 10.E1-11 and E1-12 are disregarded when set to 0.0.
* 11.E1-13 is set to the same value as E1-05 by autotuning.
* 12.The values in parentheses indicate factory settings when initialized in 3-wire sequence.
* 13.If the setting is 0, the axis will accelerate to the specified speed over the specified acceleration time (C1-01 to C1-08).
* 14.C6-01 = 1:120%, C6-01 = 0:150%
* 15.This constant can be monitored or set only when F is set for C6-02.
* 16.Applicable for F7-Series Inverters with software versions PRG:1031 or later.
* 17.Refer to MECHATROLINK COMMUNICATIONS INTERFACE CARD INSTRUCTIONS (TOBPC73060008) for details.
* 18.Applicable for F7-series Inverters with software versions PRG: 1032 or latter.
* 19.Applicable for F7-series Inverters with software versions PRG: 1033 or latter.
-36
10
Table 10.7 User Constants (Continued)
Fac-
Name tory
Setting
*6
0
0
0
0
0
0
0
0
0
0
0
Set-
No.
ting
T1-00 Motor 1/2 selection
T1-01 Autotuning mode selection
T1-02 Motor output power
T1-03 Motor rated voltage
T1-04 Motor rated current
T1-05 Motor base frequency
T1-06 Number of motor poles
T1-07 Motor base speed
Number of PG pulses when turn-
T1-08
ing
T1-09 Motor no-load current
Fac-
Name tory
Setting
1
*2
2
*6
0.40
*9
200.0
*6
1.90
60.0
4
1750
600
*6
1.20
Set-
ting