Copying Constants - YASKAWA CIMR-F7A Instruction Manual

Copying Constants

The Digital Operator can perform the following three functions using the built-in EEPROM (non-volatile
memory).
Store Inverter constant set values in the Digital Operator (READ)
•
Write constant set values stored in the Digital Operator to the Inverter (COPY)
•
Compare constant set values stored in the Digital Operator with Inverter constants (VERIFY)
•
Related Constants
Con-
Name
stant
Number
0: Normal operation
Copy func- 1: READ (Inverter to Operator)
o3-01
tion selection 2: COPY (Operator to Inverter)
3: Verify (compare)
Read permit- 0: Read prohibited
o3-02
ted selection 1: Read permitted
COPY Function Selection (SPEC: E or Later Only)
The available COPY functions (o3-01 "Copy function selection") differ depending on the SPEC of Inverter as
shown in the table below.
READ Source
COPY Destination
→
READ (Inverter Operator)
→
READ (Inverter Operator)
VERIFY
* The initial values of user constants that have been stored using the constant o2-03 cannot be copied.
Setting
Description
Range
0 to 3
0 or 1
Inverter with Inverter with
SPEC: C or SPEC: C or
earlier
(PRG:101 ) (PRG:101 )
Inverter with Inverter with
SPEC: C or
earlier
(PRG:101 ) (PRG:103 )
Available
Available
Available
Digital Operator Functions
Control Methods
Change
Factory during
V/f
Setting Opera-
V/f with
tion
PG
0 No A A
0 No A A
Inverter with
SPEC: E or
earlier earlier
(PRG:103 )
Inverter with
SPEC: E or SPEC: C or
earlier earlier
(PRG:101 )
Available Available
*
N/A
Available
N/A N/A
MEMO
Open
BUS
Flux
Loop
Regis-
Vec-
Vec-
ter
tor
tor
A A 515H
A A 516H
Inverter with
SPEC: E or
earlier
(PRG:103 )
Inverter with
SPEC: E or
earlier
(PRG:103 )
Available
Available
Available
6-
151