YASKAWA CIMR-F7A Instruction Manual page 289

Con-
stant
Number
Bias (termi-
H4-06
nal AM)
Analog out-
put 1 signal
H4-07
level selec-
tion
Channel 1
F4-01 monitor
selection
Channel 1
F4-02
gain
Channel 2
F4-03 monitor
selection
Channel 2
F4-04
gain
Channel 1
F4-05 output moni-
tor bias
Channel 2
F4-06 output moni-
tor bias
Analog out-
put signal
F4-07
level for
channel 1
Analog out-
put signal
F4-08
level for
channel 2
-92
6
Name Description
Sets the multi-function analog
output 2 voltage level bias.
Sets output characteristic up/
down parallel movement as a
percentage of 10 V.
The maximum output from the
terminal is 10 V.
A meter calibration function is
available.
Sets the signal output level for
multi-function output 1 (termi-
nal FM)
0: 0 to +10 V output
−
1: 10 to 10 V output
Effective when the Analog
Monitor Board is used.
Monitor selection:
Set the number of the monitor
item to be output. (U1-
The monitor items that can be
set depends on the control
method.
Gain:
Set the multiple of 10 V for out-
putting monitor items.
4, 10 to 14, 25, 28, 31, 34, 35,
39, 40, 42 cannot be set. 29 to 31
are not used. When the AO-12
Analog Monitor Board is used,
outputs of ± 10 V are possible.
To output ± 10 V, set F4-07 or
F4-08 to 1. When the AO-08
Analog Monitor Board is used,
only outputs of 0 to +10 V are
possible.
A meter calibration function is
available.
Sets the channel 1 item bias to
100%/10 V when the Analog
Monitor Board is used.
Sets the channel 2 item bias to
100%/10 V when the Analog
Monitor Board is used.
0: 0 to 10 V
1: -10 to +10 V
0: 0 to 10 V
1: -10 to +10 V
Change
Setting Factory during
Range Setting Opera-
tion
-10.0 to
0.0% Yes
+10.0
0 or 1 0 No
1 to 99 2 No
0.00 to
)
1.00 Yes
2.50
1 to 99 3 No
0.00 to
0.50 Yes
2.50
-10.0 to
0.0% Yes
10.0
-10.0 to
0.0% Yes
10.0
0 or 1 0 No
0 or 1 0 No
Control Methods
MEMO
Open
BUS
V/f Flux
Loop
Regis-
V/f with Vec-
Vec-
ter
PG tor
tor
A A A A 422H
A A A A 423H
A A A A 391H
A A A A 392H
A A A A 393H
A A A A 394H
A A A A 395H
A A A A 396H
A A A A 397H
A A A A 398H