YASKAWA CIMR-F7A Instruction Manual page 140

Con-
stant
Number
d5-04 Speed limit
Speed limit
d5-05
bias
Speed/
torque con-
d5-06
trol switch-
ing timer
-30
5
Name Description
Set the speed limit during
torque control as a percent-
age of the maximum output
frequency.
This function is enabled
when d5-03 is set to 2.
Directions are as follows.
+: Run Command direction
-: Run Command opposite
direction
Set the speed limit bias as a
percentage of the maximum
output frequency.
Bias is given to the specified
speed limit. It can be used to
adjust the margin for the
speed limit.
Set the delay time from
inputting the multi-function
input "speed/torque control
change" (from On to OFF or
OFF to ON) until the control
is actually changed, in ms
units.
This function is enabled
when the multi-function
input "speed/torque control
change" is set. In the speed/
torque control switching
timer, the analog inputs hold
the values of when the
"speed/torque control
change" changes. Always be
sure to allow time for this
process to finish completely.
Control Methods
Change
Setting Factory during
Range Setting Opera-
V/f
tion
-120 to
0% No No
+120
0 to
10% No No
120
0 to
0 ms No No
1000
MEMO
Open
BUS
V/f Flux Page
Loop
Regis-
with Vec-
Vec-
ter
PG tor
tor
No No A 29DH 6-129
No No A 29EH 6-129
No No A 29FH 6-130