Table of Contents
Advertisement
Connect Mode
The WAN network connection mode can be divided into :
PPPoE （ADSL user ）
Dynamic IP Address (cable modem user)
Static IP address (static connection or ADSL static line users )
Saturated Connections
Can set the WAN connections depend on the traffic, connections and packets.
Priority
Set the WAN interface priority by balance mode choice.
Service
To test if the WAN can work or not. The testing includes two parts:
ICMP：Ping the IP to see if the connection can work.
DNS： Use the domain name to see if the connection can work.
Downstream Bandwidth and Upstream Bandwidth
Can set the proper bandwidth of the WAN interface.
The Idle Time
As the WAN interface set to be the PPPoE (ADSL users) settings, the MIS engineer can set the idle time
when the WAN port is not in use. (Its unit is minute)
DMZ
Can set the DMZ in the CS-2000 appliance.
The DMZ includes two modes:
NAT：The DMZ is an isolated virtual domain. (But it can not be at the same segment as LAN).
TRANSPARENT：The DMZ and WAN interface are both in the same domain.
CS-2000 UTM Content Security Gateway User's Manual
- 41 -
Advertisement
Table of Contents
