Table of Contents
Advertisement
Enable SNMP Trap Alert Notification
Step1.
In Configure
setting:
SNMP Trap Recipient Address: enter SNMP trap recipient IP.
SNMP Trap Port: Enter the port number. (Default value: 162).
Click OK.
Complete the SNMP Trap setting. The MIS engineer can use the SNMP Trap software
and receive the alarm notification from the CS-2000 appliance.（it will send the
notification about connection / disconnection and the attacks information to the SNMP
Trap recipient
The MIS engineer can click
CS-2000 UTM Content Security Gateway User's Manual
SNMP , select Enable SNMP Trap Alert Notification and enter the following
address.
SNMP Trap setting WebUI
to test if SNMP Trap can work normally.
- 37 -
Advertisement
Table of Contents
