Table of Contents
Advertisement
Web Management (WAN Interface)
The administrator can change the port number used by HTTP port anytime. (Remote WebUI management)
After HTTP and HTTPS port have changed, if the administrator want to enter WebUI from WAN, will
have to change the port number of browser. (For example: http://61.62.108.172:8080)
Step 1.
Set Web Management (WAN Interface). Enter the new port number used by HTTP and HTTPS
port. ( Range 1 – 65535 )
Step 2.
Click OK at the bottom-right of the screen.
MTU (set networking packet length)
The administrator can modify the networking packet length.
Step 1.
MTU Setting. Modify the networking packet length. ( Range 40 – 1500 )
Step 2.
Click OK at the bottom-right of the screen.
Dynamic Routing (RIPv2)
Enable Dynamic Routing (RIPv2), CS-2000 will switch the routing information of RIP. The routers which
support RIP can connect automatically. You can choose to enable LAN, WAN1, WAN2 or DMZ interface to
allow RIP protocol supporting.
Routing information update timer: CS-2000 will send out the RIP protocol in a period of time to update the
routing table, the default timer is 30 seconds.
Routing information timeout: If CS-2000 does not receive the RIP protocol from the other router in a period
of time, CS-2000 will cut off the routing automatically until it receives RIP protocol again. The default timer is
180 seconds.
CS-2000 UTM Content Security Gateway User's Manual
Web Management
MTU Setting
Enable Dynamic Routing
- 21 -
Advertisement
Table of Contents
