Cli\Ifeatures\Linkcheck Menu Command - Siemens SCALANCE W786-xPRO Operating Instructions Manual

Configuration / project engineering
5.7 Configuration with the Command Line Interface
CLI\IFEATURES\FORCED_ROAM\WLAN1> (or \WLAN2 or \WLAN3)
Command
froam [E|D]
ip [IP address]
interval [100 - 5000]
lostpkts [1 - 5]
See also
Forced Roaming on IP Down menu command (in access point mode only) (Page 154)
5.7.7.3

CLI\IFEATURES\LINKCHECK menu command

Device-related connection monitoring
With the commands in this menu, you set the properties of device-related connection
monitoring.
CLI\IFEATURES\LINKCHECK>
Command
linkchk [E|D]
add <MAC> [timeout]
edit <Index|MAC>
[E|D] [timeout]
delete <Index|MAC>
clearall
acknow [Index|All]
214
Description
Enables of disables forced roaming on
IP down.
Monitors the connection to this IP
partner.
Specifies the monitoring cycles to the
IP partner in milliseconds.
Specifies the maximum number of
unanswered pings before the WLAN
interface is disabled.
Description
Enable / disable device-related
connection monitoring.
Adds a new MAC address for
connection monitoring and specifies
the monitoring time. No time is
specified, the default is 500 ms.
Modifies, enables, or disables an entry. ᅳ
Deletes the specified entry from the
list.
Deletes all entries for connection
monitoring.
Displays or acknowledges (clears) the
Link Check messages requiring
acknowledgment.
Comment
IWLAN/ W744 W746 W747 W78x W78x
PB LINK
ᅳ ᅳ
ᅳ ᅳ
ᅳ ᅳ
ᅳ ᅳ
Comment
IWLAN/ W744 W746 W747 W78x W78x
PB LINK
ᅳ ᅳ
ᅳ ᅳ
ᅳ
ᅳ ᅳ
ᅳ ᅳ
The fault state remains active until all the fault
messages have been acknowledged. The fault
status and the LED are cleared if the reason for
the fault status was only a link check error
message.
Operating Instructions, Release 08/2007, C79000-G8976-C221-02
RR
ᅳ ᅳ ✔ ✔
ᅳ ᅳ ✔ ✔
ᅳ ᅳ ✔ ✔
ᅳ ᅳ ✔ ✔
RR
ᅳ ᅳ ✔ ✔
ᅳ ᅳ ✔ ✔
ᅳ ᅳ ✔ ✔
ᅳ ᅳ ✔ ✔
ᅳ ᅳ ✔ ✔
SCALANCE W786-xPRO