Siemens SCALANCE W786-xPRO Operating Instructions Manual page 178

Configuration / project engineering
5.7 Configuration with the Command Line Interface
CLI\SYSTEM\EVENT>
Commands available only for access points and client modules (not for IWLAN/PB LINK):
Command
setec CW <E|D> <E|D>
<E|D> <E|D>
setec LU <E|D> <E|D>
<E|D>
setec LD <E|D> <E|D>
<E|D>
setec AF <E|D> <E|D>
<E|D>
setec PM <E|D> <E|D>
<E|D> <E|D>
setec PE <E|D> <E|D>
<E|D> <E|D>
setec FC <E|D> <E|D>
<E|D>
Commands available only for access points (not for access points in client mode, clients, IWLAN/PB
LINK):
Command
setec AP <E|D> <E|D>
<E|D> <E|D>
setec MS <E|D> <E|D>
<E|D> <E|D>
178
Description
Reactions when the
SCALANCE W-700 restarts.
Reaction to the "Link Up"
event on the Ethernet
interface.
Reaction to the "Link Down"
event on the Ethernet
interface.
Reaction to a bad
authentication over Web
Based Management, CLI, or
SNMP.
Reaction to a change of
power supply over the M12
power connection.
Reaction to a change of
power supply over Ethernet.
Reaction to a change in the
error status.
Description
Reaction to detection of an
access point on own or an
overlapping wireless channel.
Reaction when the update time
in iPCF mode with PNIO support
cannot be kept to due to an
additional client.
Comment
IWLAN/ W744 W746
PB LINK
ᅳ ✔ ✔
If the error status was triggered only due to a link down
event, the error states is cleared and the error LED goes
off.
ᅳ ✔ ✔
ᅳ ✔ ✔
The SNMP trap "AuthFault" is sent only if there is a bad
SNMP authentication.
ᅳ ✔ ✔
ᅳ ✔ ✔
ᅳ ✔ ✔
ᅳ ✔ ✔
Comment
IWLAN/ W744
PB LINK
ᅳ ᅳ
This command is available only with the following
models:
SCALANCE W788-1RR
•
SCALANCE W788-2RR
•
SCALANCE W784-1RR
•
ᅳ ᅳ
Operating Instructions, Release 08/2007, C79000-G8976-C221-02
W747 W78x
✔ ✔
✔ ✔
✔ ✔
✔ ✔
✔ ✔
✔ ✔
✔ ✔
W746 W747 W78x
ᅳ ᅳ ✔
ᅳ ᅳ ᅳ
SCALANCE W786-xPRO
W78x
RR
✔
✔
✔
✔
✔
✔
✔
W78x
RR
✔
✔