Siemens SCALANCE W786-xPRO Operating Instructions Manual page 233

Name
snScalanceWLinkIntegrity
On
snScalanceWClientAuthe
nticated
snScalanceWClientDeAut
henticated
snScalanceWRedundanc
y
Traps available only for access points
Name
snScalanceWOverlapAP
snScalanceWiPCFPNIO
maxSTAs
snScalanceWiPCFPNIOC
ycleTime
snScalanceWForcedRoa
mingVapStateChanged
SCALANCE W786-xPRO
Operating Instructions, Release 08/2007, C79000-G8976-C221-02
Specific Variables
index
82 snScalanceWLinkCheckValue - Description of
the last snScalanceWLinkCheckOn trap
85 SnScalanceWClientsIndex - An index of the
client in the snScalanceWClients table
86 SnScalanceWClientsIndex - An index of the
client in the snScalanceWClients table
53 SnScalanceWRedundancyValue- Description
of the last redundancy trap.
SnScalanceWRedundancyState- Status of
redundancy connection
Specific Variables
index
101 snScalanceWOverlapAPValue
- Description of the last OverlapAP trap.
111 snScalanceWPNIOValue - Description of the
last snScalanceWiPCFPNIOmaxSTAs or
snScalanceWiPCFPNIOCycleTime trap
112 snScalanceWPNIOValue - Description of the
last snScalanceWiPCFPNIOmaxSTAs or
snScalanceWiPCFPNIOCycleTime trap
121 snScalanceWVirtualApIndex
- Index of the VAP
snScalanceWVirtualApState
- Current State of the VAP
unknown (0)
authenticated (1)
associated (2)
powersafe (3)
adhoc (4)
joined (5)
vap-is-up (6)
vap-starting (7)
vap-is-down (8)
locked (9)
vap-connected (10)
A.1 Private MIB variables of the SCALANCE W78x / W74x
Appendix
Description
This is generated if a client
monitored with Link Check logs
on again at the AP following a
timeout.
This is generated when a client
logs on at the AP.
This is generated when a client
logs off from the AP.
This is generated if the status of
the redundant connection
changes, for example when the
connection of wireless interface A
aborts.
Description
Is generated when an
access point is detected on the
device's own or an overlapping
wireless channel.
Is generated when there are too
many clients registered for the
specified update time in iPCF
mode with PNIO support.
Is generated when the specified
update time in iPCF mode with
PNIO support cannot be kept to.
Generated when the status of the
VAP changes.
233