Siemens SCALANCE W786-xPRO Operating Instructions Manual page 99

Changing the mode of access points
When the mode changes from access point mode to client mode and back, all the
parameters are cleared except:
● IP address
● Subnet mask
● Gateway address
● SSID (only in access point mode)
● IP address of the default router
● DHCP flag
● System name
● System location
● System contact
● Device mode
● Country code
● User and Admin passwords
The "Current system time" output box informs you about the system time. The "System up
time" output box informs you about the time that has elapsed since the last restart.
Reading out the country list
In the address field of the Internet browser, enter
https://<IP address of the SCALANCE W-700>/countrylist.log
and confirm with "Enter".
After logging in, you then obtain the country list with the following headers:
------------------------------------------------------------------
COUNTRY
------------------------------------------------------------------
The table lists the permitted wireless modes and channels along with the corresponding
channel frequencies for every possible country setting. The PWR(EIRP) rubric contains the
permitted limit values for the transmit power, measured at the antenna. The limit values
relate to the transmit power of the access point and the gain of the antenna being used.
Note
In the version for USA, you cannot select a country. The frequency bands for this country are
already preset.
SCALANCE W786-xPRO
Operating Instructions, Release 08/2007, C79000-G8976-C221-02
| MODE | CH
Configuration / project engineering
5.6 Configuration with Web Based Management
| MHz | PWR(EIRP) | USAGE
99