The Security Menu; Security Menu Command - Siemens SCALANCE W786-xPRO Operating Instructions Manual

Configuration / project engineering
5.6 Configuration with Web Based Management
Description
You can only complete the pages of the virtual access points VAP1...VAP7 if you have
configured virtual access points ("Virtual AP count > 0") at the higher level "Interfaces >
WLAN".
On this page, you can assign a separate SSID to the virtual access points; in other words,
the access point operates in multiple SSID mode.
SSID
Enter the SSID of the VLAN here.
Make sure that you also store the SSID of this VLAN in the configuration of the client that
you assign to this VLAN.
Note
You can configure separate security settings for each virtual access point (see section "Basic
Wireless menu command")
The security settings of the VAPs must meet those of the relevant VLANs.
See also
CLI\INTERFACES\WLAN1\VAP1..7 (or \WLAN2\VAP1..7 or \WLAN3\VAP1..7) menu
command (Page 197)
5.6.5

The Security menu

5.6.5.1

Security menu command

Introduction
In this menu, you configure the security settings with which you want to operate your device.
Apart from selecting the authentication and encryption scheme, this also includes the
decision as to whether or not an external Radius server is used and whether access is
restricted based on MAC addresses (ACL).
See also
CLI\SECURITY menu command (Page 197)
122
Operating Instructions, Release 08/2007, C79000-G8976-C221-02
SCALANCE W786-xPRO