Cli\Interfaces\Wlan1\802.11G (Or \Wlan2\802.11G Or \Wlan3\802.11G) Menu Command - Siemens SCALANCE W786-xPRO Operating Instructions Manual

Configuration / project engineering
5.7 Configuration with the Command Line Interface
CLI\INTERFACES\WLAN1\SSID> (or \WLAN2\SSID or \WLAN3\SSID)
Command
add <network name>
edit <index> <network
name>
delete <index>
clearall
See also
SSID List menu command (Page 120)
5.7.3.5 CLI\INTERFACES\WLAN1\802.11G (or \WLAN2\802.11G or \WLAN3\802.11G) menu
command
Special options of the 802.11g standard
With the commands in this menu, you can configure specific properties of the 802.11g
standard. You can, for example, specify how management and control data is sent in
802.11g mode.
CLI\INTERFACES\WLAN1\802.11G (or \WLAN2\802.11G or \WLAN3\802.11G)
Command
ctsmode [0|1|2]
ctsrate
[0|1|2|3]
194
Description
Adds a network name (SSID)
to the SSID list.
Changes the network name
(SSID) at the <index> location
in the SSID list.
Deletes the network name
(SSID) from the SSID list at
the <index> location.
Clears all network names
(SSID) from the SSID list.
Description
Specifies whether the RTS/CTS method is
used for 802.11g packets:
0 Do not use CTS.
1 Always use CTS.
2 CTS depending on whether
802.11b clients exist.
Specifies the data rate for 802.11g CTS
frames:
0 1 Mbps
1 2 Mbps
2 5.5 Mbps
3 11 Mbps
Comment
IWLAN/ W744 W746
PB LINK
Available only in the client mode.
✔ ✔ ✔
Available only in the client mode.
✔ ✔ ✔
Available only in the client mode.
✔ ✔ ✔
✔ ✔ ✔
Comment
IWLAN/ W744 W74
PB LINK
ᅳ ᅳ
Only available in access point mode.
✔ ✔
Not with iPCF
Operating Instructions, Release 08/2007, C79000-G8976-C221-02
W747 W78x W78x
RR
✔ ✔ ✔
✔ ✔ ✔
✔ ✔ ✔
✔ ᅳ ᅳ
W747 W78x
6
ᅳ ᅳ ✔
✔ ✔ ✔
SCALANCE W786-xPRO
W78x
RR
✔
✔