Cli\Bridge\Spanning\Ports Menu Command - Siemens SCALANCE W786-xPRO Operating Instructions Manual

Configuration / project engineering
5.7 Configuration with the Command Line Interface
spanning [E|D]
version [R | S]
bridge [0 ... 61440]
hellotm [1...10]
fwd_delay [4...30]
maxage [6....40]
See also
Spanning Tree menu command (Page 140)
5.7.5.6

CLI\BRIDGE\SPANNING\PORTS menu command

Spanning tree port
With the commands in this menu, you set the Spanning Tree port properties.
CLI\BRIDGE\SPANNING\PORTS>
Command
info
portstp <E|D> [ports]
portprio <Port>
[0 ... 240]
stp_cost <Port>
[1 ... 65535]
rstp_cost <Port>
[0 ... 200000000]
206
Enables (E) or disables (D) the (R)STP
algorithm.
Specifies whether the Rapid Spanning
Tree (R) or Spanning Tree (S) mode is
used.
This specifies the bridge priority for the
SCALANCE W-700:
Specifies the interval between two
BPDUs in seconds.
Specifies the delay time for the
effectiveness of configuration
information (specified in seconds).
Maximum age for configuration
information. (specified in seconds).
Description
Displays the current spanning tree
configuration.
Enables / disables the spanning tree
algorithm for the specified ports.
Specifies the priority of the port.
Specifies the path costs for the port if
Version is set to STP.
Specifies the path costs for the port if
Version is set to RSTP. If the value is
0, the value is calculated.
Comment
ᅳ ᅳ
ᅳ ᅳ
Default value: 32768
ᅳ ᅳ
Default value: 2 s
ᅳ ᅳ
Default value: 15 s
ᅳ ᅳ
Default value: 20 s
ᅳ ᅳ
Comment
IWLAN/ W744 W746 W747 W78x W78x
PB LINK
ᅳ ᅳ
ᅳ ᅳ
ᅳ ᅳ
ᅳ ᅳ
ᅳ ᅳ
Operating Instructions, Release 08/2007, C79000-G8976-C221-02
ᅳ ᅳ ✔ ✔
ᅳ ᅳ ✔ ✔
ᅳ ᅳ ✔ ✔
ᅳ ᅳ ✔ ✔
ᅳ ᅳ ✔ ✔
ᅳ ᅳ ✔ ✔
RR
ᅳ ᅳ ✔ ✔
ᅳ ᅳ ✔ ✔
ᅳ ᅳ ✔ ✔
ᅳ ᅳ ✔ ✔
ᅳ ᅳ ✔ ✔
SCALANCE W786-xPRO