Cli\System\Fault Menu Command; Cli\System\Loadsave Menu Command - Siemens SCALANCE W786-xPRO Operating Instructions Manual

5.7.2.13

CLI\SYSTEM\FAULT menu command

Information on errors/faults
With the command in this menu, you display information on errors/faults that have occurred.
CLI\SYSTEM\FAULT>
Command
fault [OFF]
ipacknow [Index|All]
linkack [Index|All]
See also
Fault State menu command (Page 106)
5.7.2.14

CLI\SYSTEM\LOADSAVE menu command

Saving and loading device data
With the commands in this menu, you can save data from the device or load data to the
device (configuration data, firmware, authentication data etc.).
SCALANCE W786-xPRO
Operating Instructions, Release 08/2007, C79000-G8976-C221-02
Description
Display the fault status and
cause of the fault. The
"OFF" parameter resets the
fault LED and the fault
status. Ideally, however, the
cause of the problem should
be eliminated.
Displays or acknowledges
(clears) the IP Alive
messages requiring
acknowledgment.
Displays or acknowledges
(clears) the Link Check
messages requiring
acknowledgment.
Configuration / project engineering
5.7 Configuration with the Command Line Interface
Comment
IWLAN/ W744 W746
PB LINK
You can reset the LED and the fault status with the
command: "fault OFF". Ideally, however, the cause of the
problem should be eliminated.
✔ ✔ ✔
The fault state remains active until all the fault messages
have been acknowledged. The fault state and the Fault
LED are cleared if the only reason was an IP Alive error
message.
The command cannot be executed in client mode.
ᅳ ᅳ ᅳ
The fault state remains active until all the fault messages
have been acknowledged. The fault state and the Fault
LED are cleared if the only reason was a Link Check error
message.
The command cannot be executed in client mode.
ᅳ ᅳ ᅳ
W747 W78x W78x
RR
✔ ✔ ✔
ᅳ ✔ ✔
ᅳ ✔ ✔
185