Resuscitation Equipment (Optional) - Dräger WBR82 Instructions For Use Manual

PROPRIETARY AND CONFIDENTIAL DRAFT 5 Feb 04
8. Check the writing surface (Resuscitaire Birthing Room
Warmer only):
a. Pull the writing surface out from under the bassinet.
b. Return the writing surface to under the bassinet.
9. Check the cart and bassinet docking mechanism and
caster locks (Resuscitaire Birthing Room Warmer only).
a. Undock the cart and bassinet from the warmer.
b. Press the caster locks, and ensure that they keep the
cart from moving.
c. Release the caster locks, and dock the cart and bassinet onto the warmer.
10. Check the accessory instrument tray by swinging it
out from under the bassinet (Resuscitaire Radiant
Warmer only).
WARNING:
For optimum stability, always lower the Variable
Height Resuscitaire Radiant Warmer to its lowest
position prior to transport. If installed, ensure that
items placed on the shelves are properly secured.
Failure to do so could result in infant injury,
personal injury, or equipment damage.
11. Check the Variable Height (VHA) stand
(Resuscitaire Radiant Warmer only):
a. Press the upper portion of the switch on the right
side of the lower post until the upper post raises
to its maximum height.
b. Press and hold the lower portion of the switch until the upper post lowers to its minimum height.
c. Press the upper portion of the switch on the left side of the lower post until the upper post rises to
its maximum height.
d. Press and hold the lower portion of the switch until the upper post lowers to its minimum height.
e. Verify that the upper post operates smoothly, and adjust it to the desired height.

Resuscitation Equipment (Optional)

Gas Source Pressure
1. Ensure that the oxygen and air pipelines are securely attached to the appropriate fittings on the rear of
the unit and that the gas supply present is 276 kPa (40 psi) to 517 kPa (75 psi).
2. If using the reserve gas supply from cylinders, perform the following:
a. Ensure that the cylinders are properly secured in the mounting yokes on the rear of the warmer
prior to opening.
b. Ensure that the cylinder valve located on the top of the cylinder is open.
4 - 19