Examination Light - Dräger WBR82 Instructions For Use Manual

PROPRIETARY AND CONFIDENTIAL DRAFT 5 Feb 04
NOTE:
To minimize the effect of direct radiation on the skin temperature probe and obtain a more accurate baby
temperature measurement, cover the sensor with a Critter Covers Probe Cover, a Care-For-Me™ Cover,
or an equivalent insulating foam or gel cover with a reflective surface facing the warmer module.
d. Cover the probe with a reflective Critter Covers Disposable Probe Cover or a Care-For-Me™
Cover.
NOTE:
A higher set temperature setting does not increase rapid warming.
4. Set the Set Temperature display to the prescribed temperature.
NOTE:
Fluctuations in the Heater Power indicators or the Baby Temperature display reading can result from
air currents, obstructions of radiation to the infant, or the skin temperature probe not being in direct
contact with the skin.
5. Verify that the Baby Temperature display reading stabilizes within 0.2°C of the Set Temperature
display.
6. To silence any Baby Temperature alarms for 10 min, press the Silence/Reset key.
NOTE:
In the event of a Probe alarm, use Manual Mode temporarily if the skin temperature probe needs to be
disconnected until it is replaced if nursing personnel are in constant attendance.
7. After the alarm condition is corrected, any Baby Temperature, Probe, and High Temperature
alarm automatically resets. Silence the High Temperature alarm for 2 min by pressing the
Silence/Reset key.

Examination Light

1. Use the Examination Light key to turn the examination light on and off. For optimum bulb life, turn
the examination light on only as required.
WARNING:
Protect the infant's eyes from strong light from the examination lamp. Failure to do so could
result in infant injury.
2. When the examination light is on, protect the infant's eyes.
5 - 17