Link-Aggregation Selected-Port Minimum - HP 3600 v2 Series Command Reference Manual

View
Layer 2 aggregate interface view, Layer 3 aggregate interface view
Default level
2: System level
Parameters
number: Specifies the maximum number of Selected ports allowed in an aggregation group. This
argument ranges from 1 to 8.
Description
Use link-aggregation selected-port maximum to configure the maximum number of Selected ports
allowed in the aggregation group.
Use undo link-aggregation selected-port maximum to restore the default setting.
By default, the maximum number of Selected ports allowed in an aggregation group is 8
Executing this command may cause some of the member ports in the aggregation group to become
unselected.
The maximum numbers of Selected ports for the local and peer aggregation groups must be consistent.
Examples
# Configure the maximum number of Selected ports as 3 in the aggregation group corresponding to
Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation selected-port maximum 3

link-aggregation selected-port minimum

Syntax
link-aggregation selected-port minimum number
undo link-aggregation selected-port minimum
View
Layer 2 aggregate interface view, Layer 3 aggregate interface view
Default level
2: System level
Parameters
number: Specifies the minimum number of Selected ports in an aggregation group required to bring up
the aggregate interface. This argument ranges from 1 to 8.
Description
Use link-aggregation selected-port minimum to configure the minimum number of Selected ports in the
aggregation group.
Use undo link-aggregation selected-port minimum to restore the default setting.
By default, the minimum number of Selected ports in an aggregation group is not specified.
96