Mac-Address (System View) - HP 3600 v2 Series Command Reference Manual

By default, no MAC address entry is configured on an interface.
The MAC address entries configuration cannot survive a reboot unless you save it. The dynamic MAC
address table entries, however, are lost at next reboot whether or not you save the configuration.
Related commands: display mac-address.
Examples
# Add a static entry for MAC address 000f-e201-0101 on port Ethernet 1/0/1 that belongs to VLAN 2.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] mac-address static 000f-e201-0101 vlan 2
# Add a static entry for MAC address 000f-e201-0102 on port Bridge-Aggregation 1 that belongs to
VLAN 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] mac-address static 000f-e201-0102 vlan 1

mac-address (system view)

Syntax
mac-address blackhole mac-address vlan vlan-id
mac-address { dynamic | static } mac-address interface interface-type interface-number vlan vlan-id
undo mac-address [ { dynamic | static } mac-address interface interface-type interface-number vlan
vlan-id ]
undo mac-address [ blackhole | dynamic | static ] [ mac-address ] vlan vlan-id
undo mac-address [ dynamic | static ] mac-address interface interface-type interface-number vlan
vlan-id
undo mac-address [ dynamic | static ] interface interface-type interface-number
View
System view
Default level
2: System level
Parameters
blackhole: Specifies blackhole MAC address entries. These entries do not age, but you can add or
remove them. The packets whose source or destination MAC addresses match the blackhole MAC
address entries are dropped.
mac-address: Specifies a MAC address in the format of H-H-H, where 0s at the beginning of each H
(16-bit hexadecimal digit) can be omitted. For example, inputting "f-e2- 1 " indicates that the MAC
address is 000f-00e2-0001.
vlan vlan-id: Specifies an existing VLAN to which the Ethernet interface belongs, where vlan-id is the
specified VLAN ID, in the range of 1 to 4094.
dynamic: Specifies dynamic MAC address entries, which can be aged.
static: Specifies static MAC address entries. These entries do not age, but you can add or remove them.
66