Port Isolate-User-Vlan Promiscuous - HP 3600 v2 Series Command Reference Manual

After you configure the isolated-vlan enable command in VLAN view, you cannot assign any port in the
VLAN to an isolation group.
Layer 2 isolation configured with the isolated-vlan enable command takes effect only after the secondary
VLAN is associated with an isolate-user-VLAN.
Related commands: isolate-user-vlan.
Examples
# Configure Layer 2 isolation between ports in secondary VLAN 4, where Ethernet 1/0/1 is the uplink
port and Ethernet 1/0/2 and Ethernet 1/0/3 are the downlink ports.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] isolate-user-vlan enable
[Sysname-vlan2] quit
[Sysname] vlan 4
[Sysname-vlan4] quit
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] port isolate-user-vlan 2 promiscuous
[Sysname-Ethernet1/0/1] quit
[Sysname] interface ethernet 1/0/2
[Sysname-Ethernet1/0/2] port access vlan 4
[Sysname-Ethernet1/0/2] port isolate-user-vlan host
[Sysname-Ethernet1/0/2] quit
[Sysname] interface ethernet 1/0/3
[Sysname-Ethernet1/0/3] port access vlan 4
[Sysname-Ethernet1/0/3] port isolate-user-vlan host
[Sysname-Ethernet1/0/3] quit
[Sysname] isolate-user-vlan 2 secondary 4
[Sysname] vlan 4
[Sysname-vlan4] isolated-vlan enable

port isolate-user-vlan promiscuous

Syntax
port isolate-user-vlan vlan-id promiscuous
undo port isolate-user-vlan
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
vlan-id: Specifies a VLAN ID, in the range of 2 to 4094.
Description
Use port isolate-user-vlan promiscuous to configure a port to operate in promiscuous mode in a VLAN.
Use undo port isolate-user-vlan to restore the default.
199