Protocol-Based Vlan Configuration Commands; Display Protocol-Vlan Interface - HP 3600 v2 Series Command Reference Manual

Default level
2: System level
Parameters
mac-vlan: Matches VLANs based on single MAC addresses preferentially.
ip-subnet-vlan: Matches VLANs based on IP subnets preferentially.
Description
Use vlan precedence to set the order of VLAN matching.
Use undo vlan precedence to restore the default.
By default, VLANs are matched based on single MAC addresses preferentially.
This command only applies to VLANs based on a single MAC address and IP subnet-based VLANs.
If both the MAC-based VLAN function and the IP subnet-based VLAN function are created on a port,
MAC address-to-VLAN entries are matched preferentially, and the remaining VLAN entries (VLAN entries
based on a single MAC address and IP subnet-based VLANs) are matched as configured by the vlan
precedence command.
Examples
# Configure matching VLANs based on single MAC addresses preferentially on Ethernet 1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] vlan precedence mac-vlan

Protocol-based VLAN configuration commands

display protocol-vlan interface

Syntax
display protocol-vlan interface { interface-type interface-number1 [ to interface-type interface-number2 ]
| all } [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
2: System level
Parameters
interface-type interface-number1: Specifies an interface by its type and number.
interface-type interface-number1 to interface-type interface-number2: Specifies an interface range.
all: Displays information about protocol-based VLANs on all ports.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
181