HP 3600 v2 Series Command Reference Manual page 268

max-frame-size: Advertises maximum frame size TLVs.
power: Advertises power via MDI TLVs and power stateful control TLVs.
med-tlv: Advertises LLDP-MED TLVs.
capability: Advertises LLDP-MED capabilities TLVs.
inventory: Advertises the following TLVs: hardware revision, firmware revision, software revision, serial
number, manufacturer name, model name, and asset ID.
location-id: Advertises location identification TLVs.
civic-address: Inserts the normal address information about the network device in location identification
TLVs .
device-type: Sets a device type value, ranging from 0 to 2. Value 0 specifies a DHCP server. Value 1
specifies a switch. Value 2 specifies an LLDP-MED endpoint.
country-code: Sets a country code, corresponding to ISO 3166.
{ ca-type ca-value }&<1- 1 0>: Configures address information, where ca-type represents the address
information type, ranging from 0 to 255, ca-value represents address information, a string of 1 to 250
characters, and &<1- 1 0> indicates that you can enter up to 10 parameters.
elin-address: Inserts telephone numbers for emergencies in location identification TLVs.
tel-number: Sets the telephone number for emergencies, a string of 10 to 25 characters.
network-policy: Advertises network policy TLVs.
power-over-ethernet: Advertises extended power-via-MDI TLVs.
Description
Use lldp tlv-enable to configure the types of advertisable TLVs for a port or all ports in a port group.
Use undo lldp tlv-enable to disable the advertising of specific types of TLVs.
By default, the device can advertise on a Layer 2 Ethernet port all types of LLDP TLVs, except location
identification TLVs, and advertise on a Layer 3 Ethernet port all types of LLDP TLVs, except IEEE 802.1
organizationally specific TLVs, network policy TLVs, and location identification TLVs.
To enable the device to advertise LLDP-MED TLVs, you must first enable it to advertise LLDP-MED
capabilities TLVs.
To disable the device from advertising LLDP-MED capabilities TLVs, you must first disable it from
advertising other LLDP-MED TLVs.
To disable the device from advertising MAC/PHY configuration/status TLVs, you must first disable it from
advertising LLDP-MED capabilities TLVs.
If you enable the device to advertise LLDP-MED capabilities TLVs, you also enable it to advertise
MAC/PHY configuration/status TLVs.
To enable the device to advertise multiple types of TLVs, you can execute the lldp tlv-enable command
repeatedly without the all keyword specified.
Examples
# Enable the device to advertise link aggregation TLVs of the IEEE 802.3 organizationally specific TLVs
on Ethernet 1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
260