HP 3600 v2 Series Command Reference Manual page 192

Description
Use port hybrid protocol-vlan to associate the hybrid ports with a protocol-based VLAN.
Use undo port hybrid protocol-vlan to remove the association.
The configuration made in Layer 2 Ethernet interface view applies only to the port.
The configuration made in port group view applies to all ports in the port group.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its
aggregation member ports.
• If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
If the system fails to apply the configuration to an aggregation member port, it skips the port and
•
moves to the next member port.
Before you use this command, make the following configurations:
Create a VLAN and associate it with specified protocols.
•
Configure the link type as hybrid.
•
Configure the port to allow the protocol-based VLAN to pass through.
•
Related commands: display protocol-vlan interface.
Examples
# Associate the hybrid port Ethernet 1/0/1 with protocol 0 (IPv4) in VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] protocol-vlan ipv4
[Sysname-vlan2] quit
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] port link-type hybrid
[Sysname-Ethernet1/0/1] port hybrid vlan 2 untagged
Please wait... Done
[Sysname-Ethernet1/0/1] port hybrid protocol-vlan vlan 2 0
# Associate the hybrid Layer 2 aggregate interface Bridge-Aggregation 1 with protocol 0 in VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] protocol-vlan ipv4
[Sysname-vlan2] quit
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type hybrid
[Sysname-Bridge-Aggregation1] port hybrid vlan 2 untagged
Please wait... Done
Configuring Ethernet1/0/1... Done.
Configuring Ethernet1/0/2... Done.
Configuring Ethernet1/0/3... Done.
[Sysname-Bridge-Aggregation1] port hybrid protocol-vlan vlan 2 0
The output shows that Ethernet 1/0/1, Ethernet 1/0/2, and Ethernet 1/0/3 are the member ports of the
aggregation group corresponding to Bridge-Aggregation 1.
184