Multicast-Suppression - HP 3600 v2 Series Command Reference Manual

normal: Sets the MDI mode to normal. In normal mode, pins 1 and 2 of the port are transmit pins, and
pins 3 and 6 are receive pins.
Description
Use mdi to configure the MDI mode of a copper Ethernet interface.
Use undo mdi to restore the default.
By default, Ethernet interfaces operate in auto MDI mode.
NOTE:
This command is not applicable to fiber ports.
Examples
# Set Ethernet 1/0/1 to operate in across MDI mode.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] mdi across

multicast-suppression

multicast-suppression { ratio | pps max-pps | kbps max-kbps }
undo multicast-suppression
View
Layer 2 Ethernet interface view, port group view
Default level
2: System level
Parameters
ratio: Sets the multicast suppression threshold as a percentage of the maximum interface rate, ranging
from 1 to 100. The smaller the percentage, the less multicast traffic is allowed to pass through.
pps max-pps: Specifies the maximum number of multicast packets that the Ethernet interface can forward
per second.
For FE ports, the max-pps argument ranges from 1 to 1,488,10 pps.
•
For GE ports, the max-pps argument ranges from 1 to 14,881,00 pps.
•
kbps max-kbps: Specifies the maximum number of kilobits of multicast traffic that the Ethernet interface
can forward per second.
For FE ports, the max-kbps argument ranges from 1 to 1,000,00 kbps.
•
For GE ports, the max-kbps argument ranges from 1 to 10,000,00 kbps.
•
Description
Use multicast-suppression to set the multicast suppression threshold on one or multiple Ethernet
interfaces.
Use undo multicast-suppression to restore the default.
By default, Ethernet interfaces do not suppress multicast traffic.
38