Stp Compliance - HP 3600 v2 Series Command Reference Manual

Examples
# In MSTP mode, set the network diameter of the switched network to 5.
<Sysname> system-view
[Sysname] stp bridge-diameter 5
# In PVST mode, set the network diameter of VLAN 2 to 5.
<Sysname> system-view
[Sysname] stp mode pvst
[Sysname] stp vlan 2 bridge-diameter 5

stp compliance

Syntax
stp compliance { auto | dot1s | legacy }
undo stp compliance
View
Ethernet interface view, port group view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
auto: Configures the ports to recognize the MSTP BPDU format automatically and determine the format
of MSTP BPDUs to send.
dot1s: Configures the ports to receive and send only standard-format (802.1s-compliant) MSTP BPDUs.
legacy: Configures the ports to receive and send only compatible-format MSTP BPDUs.
Description
Use stp compliance to configure the mode the specified ports will use to recognize and send MSTP
BPDUs.
Use undo stp compliance to restore the default.
By default, a port automatically recognizes the formats of received MSTP packets and determines the
formats of MSTP packets to be sent based on the recognized formats.
Configured in Ethernet interface view, the setting takes effect on that interface only.
Configured in port group view, the setting takes effect on all ports in the port group.
Configured in Layer 2 aggregate interface view, the setting takes effect only on the aggregate interface.
Configured on a member port in an aggregation group, the setting takes effect only after the port leaves
the aggregation group.
Examples
# Configure Ethernet 1/0/1 to receive and send only standard-format (802.1s) MSTP packets.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] stp compliance dot1s
128