Promise Vess A2600 Product Manual page 54

Vess A2000 Series NVR Storage Appliance
s 1: r
tep emove controller modUle
To remove the controller module of the Vess A2600 or Vess A2600s:
1. Power off the Vess system and wait until it is completely shut down.
2. Use a Phillips head screwdriver or your fingers to loosen the screw that secures the lever used to remove
and insert the controller, then pull the lever out so that the controller is unseated from the Vess chassis.
3. Pull the controller module straight back and out of the Vess chassis.
s 2: r
tep emove fAn modUle
To remove the fan module from the controller:
1. Use a Phillips head screwdriver to remove the two screw that secure the fan, one screw is in the upper
left corner, the other in the lower right corner of the module.
2. Pull the fan module out of the controller.
See illustration on next page.
48
Promise Technologies