Table of Contents
Advertisement
Product Manual
Enable sensor output in CLI
To enable the alarm connected to the sensor device, that is, to enable the ability of the terminal
board send a signal to the alarm when the sensor device is triggered, follow these steps:
1. Open the CLI interface, type
<enclosure –a mod –s "alarmstatus=1">
2. To check the Alarm Status, type <enclosure -v>
Change the Alarm Status to enable or disable the connected external alarm device.
See "Terminal Board FAQ" on page 358 for more information.
IO Terminal Board Information
353
- Quick Links:
- H Ardware
- Using the Clu
Hide quick links:
Advertisement
Table of Contents
