Promise Vess A2600 Product Manual page 50

Vess A2000 Series NVR Storage Appliance
P o v
ower n eSS
With the power supplies connected, the system can now be powered on.
To power on the Vess A2200 or Vess A2200s, press the Power button in the lower left corner of the front panel
(see figure below). Observe the LEDs on the front panel to make certain the boot up proceeds smoothly.
Vess A2200/A2200s front left side
Power LED
Power button
When the boot-up is finished and the Vess A2200/A2200s system is functioning normally:
LED Description
Power
Lights BLUE to indicate the system is powered on. Blinks BLUE in shutdown mode.
System Status
Lights GREEN when healthy, RED if there is a critical problem (LD offline, fan malfunction, voltage
out of range, system temperature alert), blinks RED for HDD high temperature alert remains dark
when not ready.
HDD Status One LED for each HDD carrier. Each LED lights GREEN when healthy, RED if the RAID member is
offline or there is a physical disk error, ORANGE indicates the drive is rebuilding, and a dark LED
indicates either no drive is installed or the drive is not configured.
Fan Status
Lights GREEN when healthy, RED indicates a fan in the CPU module is not operating in normal
range, ORANGE indicates the CPU fan module is not present.
Network
One LED for each LAN port. Lights GREEN to indicate a valid link, blinks GREEN to indicate activ-
ity on the port.
a2200/a2200
S
44
Promise Technologies