Promise Vess A2600 Product Manual page 28

Vess A2000 Series NVR Storage Appliance
m 3u
ounting a
To install the Vess into a rack with the supplied mounting rails:
1. Check the fit of the mounting rails in your rack system.
2. Adjust the length of the mounting rails as needed.
• The rear rail slides inside the front rail. The rail halves are riveted together and use no adjustment
screws.
• The front-left and front-right mounting rail ends are labeled.
• Be sure the front rail support is on the bottom facing inward.
Installing the rails onto the rack
Front left label
Support flange on the front
end of each rail
• All rail ends, front and rear, attach at the outside of the rack posts.
• The guide pins at the rail ends align with the holes in the rack posts.
• Use the attaching screws and flange nuts from your rack system. Tighten the screws and nuts according
to instructions for your rack system.
r
encloSure in a ack
Front right label
Guide pins on rails align with holes in the rack post
22
Promise Technologies