Promise Vess A2600 Product Manual page 43

Product Manual
M
AnAgeMent
This section describes how to establish a management connection the Vess A2600/A2600s and Vess A2200/
A2200s subsystems. There are two methods to establish the physical connection used for management of the
device. Management through the Gigabit network connection is done using WebPAM PROe, a web browser based
GUI. Alternatively you can use an out-of-band connection using a VGA or HDMI monitor and USB keyboard to
access the embedded text-based CLI/CLU interface.
m p
AnAgement Ath
Vess A2600/A2600s and Vess A2200/A2200s have four Gigabit Ethernet RJ-45 ports on the rear panel for
connection to an Ethernet network. Use this connection with WebPAM PROe to login as the device administrator.
To establish the management path:
1. Attach one end of an Ethernet cable to the network connector or standard NIC in the Host PC.
Attach the other end of the Ethernet cable to one of the ports on the standard network switch.
2. Attach one end of an Ethernet cable to one of the ports on the standard network switch.
Attach the other end of the Ethernet cable to the Management Port on the Vess system.
If you have multiple Vess systems, Host PCs or Servers, repeat steps 1 and 2 as required.
3. Follow the instructions for managing the basic settings of the Vess.
p C
AtH
-
netWork connection
onneCtIons
37
Hardware Setup