Smart Dc: Wired Edge Sensor With Gem-104 - HySecurity UL 325 Quick Start - Supplemental Instructions

S dc: w
mart
1. Turn OFF AC power.
2. Connect the Green NC relay wire from Miller Edge GEM to Sensor 1, 2, or 3.
3. Connect one Red and one Green wire from GEM to SENSOR COM on Controller.
4. Connect Red wire from GEM to +24V on Controller. (Red wires are not polarity sensitive.)
5. Connect Black & White wire from GEM to edge sensor. Blue tape on Miller Edge wire indicates a 10k edge. Only
Miller edges with blue taped wire can be used with the GEM module.
6. Turn ON power.
NOTE: Make sure both AC & DC switches are ON and the red battery wire is plugged in.
7. Access the Installer Menu. Configure SENSOR setting accordingly. For example, Edge Open, Edge Close, or
Edge Both.
CAUTION
All external entrapment protection sensors must be NC
sensor outputs and wired to the SENSOR COM terminal
for monitoring and powering purposes. The sensor
becomes actively powered when the gate operator
receives a run command.
*NOTE: Make sure whichever wired input used
(SENSOR 1, 2, or 3) matches the SENSOR # configured
through the Installer Menu.
CONNECT TO GATE EDGE
WITH 10K OHM RESISTOR
Black & White
Wires
B W
MILLER EDGE
GEM
GEM: Red Wire
*NOTE: For 2 channel
capabilities, refer to Smart
DC: 2 CH Wired Edge with
GEM-204 on page 45.
www.hysecurity.com © 2016
e
Ired dGe
NOTE: Green output wire can
attach to any SENSOR input.
S1 SENSOR #1 TYPE shown in
illustration.
GEM:
Green Wires
GEM:
Red Wire
S
enSor wItH
COM
COM
COM
COM
COM
COM
COM
COM
STOP
OPEN
CLOSE
OPEN
P ARTIAL
11
SENSOR 2
OPEN
EYE
10
SENSOR 3
EXIT
EXIT
9
LOOP
LOOP
BLOCK
8
EXIT
EXIT
IN OBS
7
LOOP
LOOP
OUT OBS
6
LOOP
LOOP
CENTER
5
LOOP
LOOP
EDGE
4
SENSOR 1
EYE
SENSOR
3
COM
COM
2
+ 24 V
EMERG
1
OPEN
SHOW
LEDs
Quick Start
Gem-104
Installer Menu Settings
S1 0
SENSOR #1 TYPE
OPEN CLOSE STOP
PREV NEXT SELECT
S1 5 (EDGE OPEN)
PREV
SENSOR #1 TYPE
OPEN CLOSE STOP
SELECT
PREV NEXT
D0726 Rev. J
MENU RESET
MENU RESET
37