Operating Modes; Normal Mode; Battery Mode - Hach sc200 User Manual

Table 3. User Settings (continued)
Description
Predictive Maintenance Notices
Remote Emergency Power-off (REPO)
Input Polarity
* See "Configuring Bypass Settings" on page 48.

Operating Modes

®
Eaton 9130 UPS (700–3000 VA) User's Guide
Available Settings
[Enabled] [Disabled]
[Open] [Closed]
The Eaton 9130 front panel indicates the UPS status through the UPS
indicators (see Figure 17 on page 37).

Normal Mode

During Normal mode, the
powered from the utility. The UPS monitors and charges the batteries as
needed and provides filtered power protection to your equipment.
The UPS may at times silently implement a High Alert mode, usually
when incoming utility conditions are unfavorable. In High Alert mode,
the UPS disables the battery support test to ensure maximum capacity
from the batteries if needed. The UPS will remain in High Alert for
24 hours or until changed by a Power Strategy command before
returning to its previous mode.
Optional High Efficiency and Energy Saving settings minimize heat
contribution to the rack environment. See "User Settings" on page 40.

Battery Mode

When the UPS is operating during a power outage, the alarm beeps
once every five seconds and the
When the utility power returns, the UPS transfers to Normal mode
operation while the battery recharges.
indicator illuminates solid and the UPS is
indicator illuminates solid.
S
164201718 Rev 3 www.eaton.com/powerquality
OPERATION
Default Setting
Enabled
Open
43