Motor Logic Plus Local Programming; Figure 111: Motor Logic Plus Communication Module Terminals - Hach sc200 User Manual

Model 6 Motor Control Centers
Section 9—iMCC

Motor Logic Plus Local Programming

82
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Apply appropriate personal protective equipment (PPE) and follow safe
electrical work practices. See NFPA 70E or CSA Z462.
• Turn off all power supplying this equipment before working on or inside
the Motor Control Center.
• Use a properly rated voltage sensing device to confirm that all power is
off. Control units must be de-energized before performing maintenance
on the MCC.
• The unit disconnect switch must be locked in the "off" position before
working on equipment.
Failure to follow this instruction will result in death or serious injury.
Local programming can be used for Motor Logic Plus setpoint programming
and error readout purposes. Verify that the display is unlocked (the default
setting), and disconnect all power before performing the steps below to
accomplish local programming:
1. Turn off all power supplying this equipment before working on or inside
the equipment, and follow lockout/tagout procedures. Always use a
properly rated voltage sensing device to confirm the power is off.
2. Connect a 9 V supply to the "P" and "G" terminals using the supplied
connector, part # 80445-519-50 (see Figure 111).

Figure 111: Motor Logic Plus Communication Module Terminals

NOTE: The jumpers are for 2-wire operation.
They must be removed for 4-wire networks.
A Receive pair (–) polarity
B Receive pair (+) polarity
Y Transmit pair (–) polarity
Z Transmit pair (+) polarity
S Shield
R Remote reset switch
R Remote reset switch
G Ground (–) *
P Power (+) *
* For programming
Battery connector 9V
3. Turn the "Mode Select" switch to the parameter you are programming.
Refer to bulletin # 30072-013-98_ (see "iMCC-Related Literature" on
page 12) for a list of parameters.
4. Press and hold the "Reset/Program" button.
NOTE: The display will not illuminate for local programming if the "Mode
Select" switch is in the "Run" position.
© 1999–2012 Schneider Electric All Rights Reserved
DANGER
Red (+)
Black (–)
80459-641-01E
10/2012