Remote Control Via Usb - Rigol MSO2000A Series User Manual

RIGOL

Remote Control via USB

1. Connect the device
Connect the oscilloscope (USB DEVICE) with your PC using a USB cable.
2. Install the USB driver
This oscilloscope is a USB-TMC device. After you connect the oscilloscope to the
PC and turn both on for the first time (the oscilloscope is automatically
configured to USB interface; at the same time, make sure that Utility  IO
Setting  USB Device is set to "Computer"), the Found New Hardware
Wizard as shown in the figure below is displayed on the PC. Please install the
"USB Test and Measurement Device (IVI)" driver following the directions in the
wizard. The steps are as follows.
16-2
nd Quality Products Online at:
2
GlobalTestSupply
www.
Chapter 16 Remote Control
1
MSO2000A/DS2000A User's Guide
.com
sales@GlobalTestSupply.co