Rigol MSO2000A Series User Manual page 131
Digital oscilloscope
Hide thumbs
Also See for MSO2000A Series:
- Programming manual (376 pages) ,
- Quick manual (43 pages) ,
- Service manual (30 pages)
Table of Contents
Advertisement
Chapter 5 To Trigger the Oscilloscope
RIGOL
Trigger Mode:
Press Sweep to open the trigger mode list and select "Auto", "Normal" or "Single".
For the details, please refer to "Trigger Mode". The corresponding status light of
the current trigger mode turns on.
Trigger Setting:
Press Setting to set the trigger parameters (noise rejection) under this trigger type.
Note:
Noise rejection is grayed out and disabled automatically when the signal
source is set to any channel of D0-D15.
Trigger Level:
Press SCL and use TRIGGER
LEVEL to modify the trigger level of the SCL
channel. Press SDA and use TRIGGER
LEVEL to modify the trigger level of the
SDA channel. For the details, please refer to the introduction of "Trigger Level".
MSO2000A/DS2000A User's Guide
5-43
GlobalTestSupply
www.
.com
nd Quality Products Online at:
sales@GlobalTestSupply.co
Advertisement
Table of Contents
