RIGOL
the specified lower limit of time and lower than the specified upper limit of time.
the specified time.
the specified time.
the specified lower limit of time and lower than the specified upper limit of time.
Time Setting:
When the Slope Condition is set to
press Time and turn
time value at a relatively smaller step or turn the outer knob of the navigation
knob to adjust the time value at a relatively larger step. The range available is
from 10 ns to 1 s.
When the Slope Condition is set to
and Lower Limit respectively; adjust the time upper limit and lower limit using
or the navigation knob by referring to the method mentioned above. The
range of time upper limit is from 20 ns to 1 s. The range of the time lower limit is
from 10 ns to 999 ms.
Note:
Vertical Window and Trigger Level:
After the trigger condition setting is completed, adjust the trigger level using
TRIGGER
adjustment mode of the trigger level is different when different vertical window is
selected in slope trigger. Press Vertical and use
window or press down Vertical continuously to switch the vertical window. You can
choose to only adjust the upper limit, the lower limit or both of them.
: only adjust the upper limit of the trigger level. During the adjustment,
"UP Level" and "Slew Rate" change accordingly but "Low Level" remains
unchanged.
: only adjust the lower limit of the trigger level. During the adjustment,
"Low Level" and "Slew Rate" change accordingly but "UP Level" remains
unchanged.
: adjust the upper and lower limits of the trigger level at the same time.
During the adjustment, "UP Level" and "Low Level" change accordingly but
"Slew Rate" remains unchanged.
5-22
nd Quality Products Online at:
: trigger when the negative slope time of the input signal is greater than
: trigger when the negative slope time of the input signal is lower than
: trigger when the negative slope time of the input signal is greater than
or the inner knob of the navigation knob to adjust the
The time lower limit must be lower than the upper limit.
LEVEL to correctly trigger the signal and obtain stable waveform. The
GlobalTestSupply
www.
Chapter 5 To Trigger the Oscilloscope
,
,
or
, press Upper Limit
or
to select the desired vertical
MSO2000A/DS2000A User's Guide
.com
,
sales@GlobalTestSupply.co