Rigol MSO2000A Series User Manual page 54

RIGOL
13. Analog Channel Label/Waveform
Different channels are marked with different colors and the colors of the channel
label and waveform are the same.
14. CH2 Vertical Scale
Display the on/off status of CH2 and the voltage value per grid of CH2 waveform
vertically. In addition, the following labels will be displayed according to the
current channel setting: channel coupling (e.g.
and bandwidth limit (e.g.
parameter.
15. Digital Channel Status Area
Display the current status of the 16 digital channels (D0 to D15 from right to
left). The digital channels currently turned on are displayed in green, the digital
channel currently selected is displayed in red and the digital channels currently
turned off are displayed in grey.
Note:
oscilloscopes.
16. Message Box
Display the prompt messages.
17. Source1 Waveform
Display the type of the waveform currently selected by Source1.
When the impedance of the signal source is set to 50 Ω,

displayed at the right of the Source1 waveform.
When the modulation is enabled,

Source1 waveform.
Note:
oscilloscopes.
18. Source2 Waveform
Display the type of the waveform currently selected by Source2.
When the impedance of the signal source is set to 50 Ω,

displayed at the right of the Source2 waveform.
When the modulation is enabled,

Source2 waveform.
1-24
nd Quality Products Online at:
). You can use VIRTICAL
This function is only applicable to MSO2000A and MSO2000A-S models
This function is only applicable to MSO2000A-S and DS2000A-S models
GlobalTestSupply
www.
Chapter 1 Quick Start
), input impedance (e.g.
SCALE to modify this
will be displayed at the right of the
will be displayed at the right of the
MSO2000A/DS2000A User's Guide
.com
)
will be
will be
sales@GlobalTestSupply.co