Rigol MSO2000A Series User Manual page 163

Chapter 6 MATH and Measurements
Voltage Parameters
Vmax
Vpp
Vmin
1. Vmax: the voltage value from the highest point of the waveform to the GND.
2. Vmin: the voltage value from the lowest point of the waveform to the GND.
3. Vpp: the difference between the maximum value and the minimum value of the
waveform.
4. Vtop: the voltage value from the flat top of the waveform to the GND.
5. Vbase: the voltage value from the flat base of the waveform to the GND.
6. Vamp: the difference between the top value and the base value of the
waveform.
7. Vavg: the arithmetic average value of the voltage values of the waveform points
(relative to the GND). The calculation formula is as shown below.
Wherein,
the total number of points being measured.
8. Vrms-N: the root mean square value of the voltage values of the waveform
points (relative to the GND). The calculation formula is as shown below.
MSO2000A/DS2000A User's Guide
nd Quality Products Online at:
Overshoot
Vtop
Vamp
Vbase
Preshoot
Figure 6-5 Voltage Parameters
is the measurement result of the i
x
i
GlobalTestSupply
www.
∑
n
x
i
i 1 =
Average =
n
th
point being measured;
∑
n
2
x
i
i 1 =
RMS =
n
.com
RIGOL
is
n
6-21
sales@GlobalTestSupply.co