Rigol MSO2000A Series User Manual page 174

RIGOL
The Y cursors are a pair of horizontal solid/dotted lines and are usually used

to measure voltage parameters.
The X-Y cursors are a pair of vertical solid/dotted lines and a pair of

horizontal solid/dotted lines and are usually used to measure time and
voltage parameters at the same time.
Note:
cannot be set.
2. Select Measurement Source
Press Source to select the waveform of the analog channels (CH1 or CH2),
math operation results (MATH) or LA waveform for measurement. If "None" is
selected, no cursor will be displayed.
Note:
selected.
3. Select Screen Region
When Zoom is enabled (pressing the HORIZONTAL

enables Zoom), the screen is divided into two regions, Main and Zoom.
Press Screen to select "Main" or "Zoom". When "Main" is selected, the
cursors are displayed in the main region and measure the signal displayed
in the main region. The measurement results are displayed in the zoom
region. When "Zoom" is selected, the cursors are displayed in the zoom
region and measure the signal displayed in the zoom region. The
measurement results are displayed in the main region.
Note:
parameters in the Zoom region can be measured.
When Zoom is disabled, "Main" is automatically selected in Screen and

cannot be modified.
4. Select X (Y) Axis Unit
When the measurement source is "CH1", "CH2" or "MATH"
When the display mode is "X" or "X-Y", press Time Unit to select "s", "Hz", "°" or
s: in the measurement results, A->X, B->X and △X denote time and 1/△X
"%".

Hz: in the measurement results, A->X, B->X and △X denote frequency and
denotes frequency.

1/△X denotes time.
6-32
nd Quality Products Online at:
When the current measurement source is LA, the cursor type is "X" and
For CH1, CH2, MATH and LA, only channel currently enabled can be
When the current measurement source is LA or MATH, only the
GlobalTestSupply
www.
Chapter 6 MATH and Measurements
SCALE can
MSO2000A/DS2000A User's Guide
.com
sales@GlobalTestSupply.co