Horizontal Reference - Rigol MSO2000A Series User Manual

Chapter 3 To Set the Horizontal System

Horizontal Reference

Horizontal reference is the reference position according to which the screen
waveform is expanded or compressed horizontally when adjusting HORIZONTAL
SCALE. In Y-T mode and the delayed sweep is disabled, press MENU  HorRef
in the horizontal control area (HORIZONTAL) at the front panel to select the desired
reference mode and the default is "Center".
Note:
when the delayed sweep is enabled.
1. Center
When changing the horizontal time base, the waveform is expanded or
compressed horizontally around the center of the screen.
2. Trig Pos
When changing the horizontal time base, the waveform is expanded or
compressed horizontally around the trigger point.
3. User
When changing the horizontal time base, the waveform is expanded or
compressed horizontally around the user-defined reference position.
After this mode is selected, press RefPos and rotate
reference position. The range is from -350 (the rightmost of the screen) to 350
(the leftmost of the screen) and the default is 0 (the center of the screen). Press
MSO2000A/DS2000A User's Guide
nd Quality Products Online at:
This function is not available in X-Y mode and Roll mode as well as in Y-T mode
down to restore the reference position to 0.
GlobalTestSupply
www.
to set the user-defined
.com
sales@GlobalTestSupply.co
RIGOL
3-9