To Output Ramp - Rigol MSO2000A Series User Manual
Digital oscilloscope
Hide thumbs
Also See for MSO2000A Series:
- Programming manual (376 pages) ,
- Quick manual (43 pages) ,
- Service manual (30 pages)
Table of Contents
Advertisement
Chapter 13 Signal Source
RIGOL
To Output Ramp
Press Setup1 to open the waveform setting menu. Press Wave and select "Ramp".
At this point, you can set the ramp parameters. For the detailed setting method, refer
to the introduction in "To Output Sine". This section only introduces "Symmetry".
Symmetry
It is defined as the percentage that the rising period of the ramp takes up in the
whole period.
t
Symmetry=t/T*100%
T
Set the symmetry
Press Symmetry and use
or the navigation knob to set the symmetry of the
ramp waveform. The range is from 0% to 100%. The default is 10.0%.
MSO2000A/DS2000A User's Guide
13-5
GlobalTestSupply
www.
.com
nd Quality Products Online at:
sales@GlobalTestSupply.co
Advertisement
Table of Contents
