Code Table Fault Group/Device Code (No. 19) - ABB i-bus KNX Product Manual


ABB i-bus KNX
Appendix
A.6

Code table Fault group/device code (no. 19)

Using the communication object Fault group/device code, there is the option of representing coded
information concerning the malfunction state of the lighting group or the individual device on the KNX.
For further information, see:
Lamp and ballast faults are sent in a 1 byte communication object together with the number of the DALI
device or the lighting group.
Whether the communication object contains the fault status of the lighting group or of an individual DALI
device is set in the
failed group or failed device. This parameter is visible if the parameter "Fault Group/Device Code" enable
encoded fault message has been parameterized with Yes and the communication object has been
enabled.
The values read via the communication object can be interpreted as follows:
Group-orientated setting:
No fault
Lamp fault
Ballast fault
Device-based setting:
No fault
Lamp fault
Ballast fault
The following code table shows the relationship between the DALI device and/or the lighting group and its
fault status (lamp or ballast fault).
206 2CDC 507 100 D0202 | DLR/S 8.16.1M
Communication object no.
Parameter window Status -
0...15
Value +1
64...79
Value -63
128...143
Value -127
0...63
Value +1
64...127
Value -63
128...191
Value -127
19, page 137
Central, page 61, using the parameter Send number of the
= Number of the lighting group
= Number of the lighting group
= Number of the lighting group
= Number of DALI device (ballast no.)
= Number of DALI device (ballast no.)
= Number of DALI device (ballast no.)