ABB i-bus KNX Product Manual page 127


ABB i-bus KNX
Commissioning
No.
3
This communication object is always enabled and indicates if the additional functions (Light control or Slave) are operating.
Bit value:
Bit 0 contains the information of the lighting group 1, bit 15 contains the information concerning the status of the additional
function of lighting group 16.
The example clarifies the interpretation of the communication object:
This is a 2-byte communication object. The value read from the communication object, e.g. 1058 ( = 2
with the binary code below.
This means that, for lighting groups 11, 6 and 2, an additional function (Light control or Slave) is activated for each and that
they operate.
4
This communication object is enabled if, in the
is set with the Yes option.
Should the light controller supply voltage fail for more than one to two seconds, a fault message telegram is immediately
sent should Send on change be parameterized.
Telegram value:
Function
Status Additional functions
0 = Additional function not running
(Slave does not follow its master. The brightness of the controller lighting group does not
automatically follow the controller)
1 = Additional function not running
(Slave follows its master. The brightness of the controller lighting group automatically
follows the controller)
15 14 13 12 11
2 2 2 2 2
0 0 0 0 0
Fault controller supply
0 = No fault
1 = Fault
Object name
General
10 9 8 7 6 5
2 2 2 2 2 2
0 0 0 0 0 1
General
Parameter window General, page 43, the parameter Fault controller supply
Data type Flags
2 byte C, R, T
Non DPT
10 5
+ 2 + 2
4 3 2 1 0
2 2 2 2 2
0 0 0 1 0
1 bit C, R, T
DPT 1.005
DLR/S 8.16.1M | 2CDC 507 100 D0202 125
1
) complies