ABB i-bus KNX Product Manual page 135


ABB i-bus KNX
Commissioning
No.
11
This communication object is enabled if, in the
response of switching state for the output is parameterized with the option Yes: via object "Switch/Status".
This communication object has the same functions and properties as the communication object Switch. The status is
additionally fed back.
Telegram value:
12
This communication object is enabled if, in the
response of switching state for the output is parameterized with the option Yes: via separate object "Switch/Status".
Telegram value:
The value of the communication object directly shows the current switch state of the lamp. The status can be sent After a
change and/or After request.
13
A brightness value for all connected DALI devices is received via this communication object. Any elapsing burn-in time
currently active has a higher priority, so that under certain circumstances individual devices can only assume a brightness
of 100 % or OFF.
In the
to with a dimming speed.
Brightness values, which are above or below the predefined max. or min. dimming values (dimming thresholds), are not
set. The dimming thresholds for the individual groups as set apply.
Telegram value:
Function
Switch/Status
0 = OFF and status: all DALI devices are switched off
1 = ON and status: all DALI devices are switched on
Note
If several KNX group addresses are assigned to the communication object Switch/Status, the status
address should be set as the sending address. In a KNX group with several status messages, it is useful to
allow just a single group member to feed back the status.
Status Switch
0 = OFF and status: all lamps switched off
1 = ON and status: all lamps switched on
Brightness value
Parameter window Central, page 53, it can be parameterized whether the brightness value is jumped to or dimmed
0 = OFF, or min. dimming threshold, if parameterized
...
255 = 100 %
Object name
DALI output
Central, page 61, the parameter Status
Parameter window Status -
DALI output
Central, page 61, the parameter Status
Parameter window Status -
DALI output
Data type Flags
1 bit C, R, W, T
DPT 1.001
1 bit C, R, T
DPT 1.001
1 byte C, W
DPT 5.001
DLR/S 8.16.1M | 2CDC 507 100 D0202 133