A.6 Code Table Fault Group/Device Code (No. 19) - ABB i-bus KNX Product Manual


ABB i-bus KNX
Appendix
A.6 Code table Fault group/device code (No. 19)
Via communication object Fault group/device code there is a possibility to represent coded information
concerning the malfunction state of the lighting group or the individual device on the KNX.
For further information see
Lamp and ballast faults are sent in a 1 byte communication object together with the number of the DALI
device or the lighting group.
Whether the communication object contains the fault status of the lighting group or of an individual DALI
device is set in
group or failed device. This parameter is visible, if the parameter "Fault Group/Device Code" enable
encoded fault message has been parameterized with yes and the communication object has been
enabled.
The values read via the communication object can be interpreted as follows:
Group-orientated setting:
No fault
Lamp fault
Ballast fault
Note
The surface mounted DALI Light Controller uses only the first 8 lighting groups
Device-based setting:
No fault
Lamp fault
Ballast fault
The following code table shows the relationship between the DALI device and/or the lighting group and its
fault status (lamp or ballast fault).
202 2CDC507128D0202 | DLR/A 4.8.1.1
communication object No.
Parameter window Status -
0...15
Value
64...79
Value
128...143
Value
0...63
Value
64...127
Value
128...191
Value
19, page 133
Central, page 57 via the parameter Send number of the failed
+1 = Number of the lighting group
-63 = Number of the lighting group
-127 = Number of the lighting group
+1 = Number of DALI device (ballast No.)
-63 = Number of DALI device (ballast No.)
-127 = Number of DALI device (ballast No.)